Make a drapery rods Cable

Nov 12th

Measure the peak partitions to hold drapery rods and mark the alternative partitions the place they need to go hooks. Punch a gap in every marked for a hook level. Hits anchors (anchors or dowels) metallic or plastic hammer to sink to safe the hooks firmly to the partitions. Insert one finish of the cable by a hook, shut the hook and safe with cable clamp. In case you are utilizing coated wire to the rod with cable, you’ll want to take away the plastic coating from the top earlier than utilizing the cable clamp. Use a utility knife or razor to chop wires to take away the coating and strip the wire on the top right down to the metallic.

Maintain the tensioner on the alternative hook on the wall. Reduce the cable with a cutter. Take away the locking hook, run the cable for drapery rods by one finish and secures the cable with a cable clamp. Maintain the tensioner to hook again into the wall and stretched till the cable is taut with out gaps.

Look at the hooks to see if they’re robust low voltage cable. Reduce the surplus wire and slide the material or material panels on the drapery rods d cable. The plasticized cable permits the material glide easily.